Petra ZP 20.00 Instruction for Use download pdf (Page 4)

PETRA CLASSIC SALOON JUICER ART. 201951

Please read these instructions at your leisure and save them for future reference. The PETRA JUICER is

ideal for rapidly squeezing all types of citrus fruits and is an attractive addition to any kitchen. Before

using, we suggest that you wash the separate components (not the base motor). Refer to the section

“CLEANING”.

DESCRIPTION

1. Lid with press point

2. Juicing cone with pulp compartment

3. reservoir

4. base motor

5. On-off switch

6. indicator light

7. Drip rack

8. Drip stop

9. Lid release button

TIPS FOR USE

Plug the Petra Juicer into the socket and turn it on with the switch at the back.

The juicing cone will only turn once the lid is closed or when the lid of the juicer is removed.

PRESSING

Cut the citrus fruit into two equal halves. Place one half onto the middle of the juicing cone and press

lightly. Put a glass under the spout (first open the drip stop fig 2). Now close the lid. The juicing cone

will rotate. Exert even pressure until juice stops coming out of the fruit.

Fig. 2 Drip control mechanism open

Tip: Juicing is easier when the fruit is placed on the press point of the lid. Make sure that the fruit is

tilted slightly forward (see fig 3).

Do not press too hard. If you hear the motor rotating more slowly or if it stops, you are pressing too hard.

The motor will not become damaged because the thermal protective device turns the motor off if it is

overstrained. If this occurs, we advise you to turn the juicer off with the on/off switch. After a few minutes,

the motor will cool down and the Petra Juicer can be used again. Always switch the juicer off after use.

In some cases, it is easier to press half on the juicing cone with your hand instead of the lid. This method

is recommended when the fruit, such as small oranges, lemons and large grapefruits, do not fit onto the

juicing cone. Before pressing, the lid must be removed from motor base first. To remove the lid, press

the lid release (see fig. 4) button on the back of the closed lid and then pull the lid up. The motor will

now turn continuously.

Fig. 4 To replace the lid, follow

the above steps in reverse

order.

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Petra ZP 20.00 Instruction for Use Page 4